HP StoreAll Series Installation Manual page 212

The following events occur:
The wizard sets up the blade based on the information that you entered.
The setup wizard configures the chassis on the HP StoreAll 9730 Storage system. See
the HP StoreAll Storage Network Best Practices Guide for detailed information about
chassis components. (This step will fail if the OA IP address has not been set up or if the
blade cannot communicate with the OA.) The Active Virtual Connect is, by default, the
Virtual Connect in interconnect bay 1. If the system is at factory defaults, the administrator
passwords for OA and Virtual Connect are on the labels affixed to the back of the chassis.
If the passwords have been reset, enter the new passwords.
IMPORTANT: If you are using the default flat network layout, select Ok on the Confirming
Onboard Administrator and Virtual Connect Settings screen.
212 Expanding an existing HP StoreAll Storage system using the Setup Wizard