HP StoreAll Series Installation Manual page 216

The following events occur:
The wizard configures the OA. This process takes up to 45 minutes to complete.
The wizard verifies the VC configuration and creates a new user called hpspAdmin.
The wizard attempts to log in to the Virtual Connect manager by using the Administrator
password that you supplied earlier. If the attempt fails, you can retry the attempt or re-enter
the password. (Retry is helpful only if a timeout caused the VC password check to fail.)
When the wizard can log in to the VC manager successfully, it verifies the VC firmware
and asks you to update it if necessary.
When the firmware is at the correct level, the wizard verifies that the VC is in a default
state.
The wizard configures the VC. The setup process initially powers down blades 2 - 16,
and then powers down blade 1. On blade 1, the power remains off for approximately
3 minutes. Blade 1 then reboots twice.
18. Log in to blade1 again after the Linux login prompt appears.
The wizard makes the following checks:
216 Expanding an existing HP StoreAll Storage system using the Setup Wizard