HP StoreAll Series Installation Manual page 234

Figure 51 Network Configuration for Bond2 screen
1 1. Complete the Network Configuration screen(s):
IP Address: The IP address is the address of the server on Bond0. For a single network
installation, this is the physical address of this node. For a multiple network installation,
this is the address of the blade on the management network.
Netmask: The netmask (a 32-bit mask) divides an IP address into subnets and specifies
the available network hosts. This field is auto-filled with 255.255.0.0, but the netmask
entry may need to be modified, based on your specific network subnets.
Default Gateway: The default gateway provides a route between networks. If your default
gateway is on a different subnet than Bond0, skip this field.
Later in this procedure, you can select either web UI or ASCII mode to complete the
installation. A gateway address is required to use the web UI.
VLAN Tag ID: VLAN capabilities provide hardware support for running multiple logical
networks over the same physical networking hardware. HP StoreAll supports the ability
to associate a VLAN tag with an FSN interface. For more information, see the HP StoreAll
OS Networking Best Practices Guide.
F2 (function key): If you press F2, you can toggle between the default Network
Configuration screen and the Advanced Configuration screen. Use the Network
Configuration screen to change default entries; and use the Advanced Configuration
screen to modify parameters, such as slaves, bond options, the network role of any bond,
and so forth.
12. Do one the following from the Network Configuration screen:
Select Back to return to the Network Configuration for Data Access screen, and then go
to Step
Select Ok to accept displayed entries, and then return to
Network Configuration wizard screen, if one exists. Otherwise, if there are no other
Network Configuration wizard screens, go to
Select Cancel to exit the installation process.
Press F2 to make advanced configuration changes (for example, bond device changes),
and then go to
234 Expanding an existing HP StoreAll Storage system using the Setup Wizard
6. Any entries made on the Network Configuration screen are not saved.
Step 13.
Step 1 1 to complete the next
Step 13.