HP StoreAll Series Installation Manual page 210

7. On the Advanced Configuration screen, select a bond interface.
8. On the Advanced Configuration screen, do one of the following:
To change the number of networks, select Back to return to
To configure bond mode, select Configure, and then go to
To add a bonded interface, select Continue, and then go to
To return to the Network Configuration screen, press F2, and then return to
9. Select the appropriate bond mode from the Edit Bond Mode screen by using the UP and DOWN
arrow keys or the Tab key on your keyboard, and then select Ok.
Mode=1 (Default): Use this mode to direct all network traffic to one port. Remaining ports
act as a backup, if the designated port fails. Use this option if only a few ports exist in
the network, and the primary intent is to avoid configuration conflicts.
Mode=4 (Recommended): Use this option to balance network traffic across multiple ports.
To use this option, an Ethernet switch configuration is required.
Mode=6 (Optional): Use this option to balance network traffic across all ports and cause
traffic to a given client to be directed to one port. This option is recommended if the switch
cannot be configured.
210 Expanding an existing HP StoreAll Storage system using the Setup Wizard
Step 6.
Step 9.
Step 10
Step 5.