HP StoreAll Series Installation Manual page 223

characters in host names; uppercase characters can cause issues with HP StoreAll. Do
not use an underscore (_) in the host name.
IP Address: The IP address is the address of the server on Bond0.
Netmask: The netmask (a 32-bit mask) divides an IP address into subnets and specifies
the available network hosts. This field is auto-filled with 255.255.0.0, but the netmask
entry may need to be modified, based on your specific network subnets.
Default Gateway: The default gateway provides a route between networks. If your default
gateway is on a different subnet than Bond0, skip this field.
Later in this procedure, you can select either web UI or ASCII mode to complete the
installation. A gateway address is required to use the web UI.
VLAN Tag ID: VLAN capabilities provide hardware support for running multiple logical
networks over the same physical networking hardware. HP StoreAll supports the ability
to associate a VLAN tag with an FSN interface. For more information, see the HP StoreAll
Storage Network Best Practices Guide.
F2 (function key): If you press F2, you can toggle between the default Network
Configuration screen and the Advanced Configuration screen. Use the Network
Configuration screen to change default parameters; and use the Advanced Configuration
screen to modify parameters, such as slaves, bond options, the network role of any bond,
and so forth.
8. If you pressed F2 in
screen, and select Ok.
9. On the Advanced Configuration screen, select a bond interface.
Expanding an HP StoreAll Storage 8800/9320 10 GbE cluster with an HP StoreAll 9730 module 223
Step 7, enter the total number of networks on the Get Total Networks