HP StoreAll Series Installation Manual page 209

Complete the Network Configuration screen(s):
Hostname: The host name (in the example, Bond0) can include alphanumeric characters
and the hyphen ( ) special character. It is a best practice to use only lowercase characters
in host names; uppercase characters can cause issues with the HP StoreAll OS Software.
Do not use an underscore (_) in the host name.
IP Address: The IP address is the address of the server on Bond0.
Netmask: The netmask (a 32-bit mask) divides an IP address into subnets and specifies
the available network hosts. This field is auto-filled with 255.255.0.0, but the netmask
entry may need to be modified, based on your specific network subnets.
Default Gateway: The default gateway provides a route between networks. If your default
gateway is on a different subnet than Bond0, skip this field.
Later in this procedure, you can select either web UI or ASCII mode to complete the
installation. A gateway address is required to use the web UI.
VLAN Tag ID: VLAN capabilities provide hardware support for running multiple logical
networks over the same physical networking hardware. HP StoreAll supports the ability
to associate a VLAN tag with an FSN interface. For more information, see the HP StoreAll
Storage Network Best Practices Guide.
F2 (function key): If you pressed F2 in
Configuration screen and the Advanced Configuration screen. Use the Network
Configuration screen to change default parameters; and use the Advanced Configuration
screen to modify parameters, such as slaves, bond options, the network role of any bond,
and so forth.
6. If you press F2, enter the number of networks on the Get Total Networks screen, and then
select Ok.
Expanding an HP StoreAll Storage 8800/9320 10 GbE cluster with an HP StoreAll 9730 module 209
Step 5, you can toggle between the default Network