Replacing The Riser Card In Riser Module 1; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

9.4.8

Replacing the riser card in riser module 1

Field Replaceable Units (FRU)
Average task duration: 5 minutes
V
CAUTION!
Before installing/removing expansion cards to/from the server, turn
●
off the server, all peripheral devices, and any other connected
devices. Also unplug all power cables from the outlet. Failure to do so
can cause electric shock.
The circuit boards and soldered parts of internal options are exposed
●
and can be damaged by static electricity. Before handling them, first
touch a metal part on the server to discharge static electricity from
your body.
Do not touch the circuitry on boards and soldered parts. Hold the
●
metallic areas or the edge of the circuit boards.
Follow the safety instructions in chapter
●
page 43.
9.4.8.1

Required tools

Preliminary and concluding steps: tool-less
●
Main steps: Phillips PH2 / (+) No. 2 screw driver
●
9.4.8.2

Preliminary steps

Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
6. "Locating the defective component" on page 58
RX100 S7
Upgrade and Maintenance Manual
Expansion cards and backup units
"Important information" on
227