Replacing An Expansion Card In The Riser Module - Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual

9.7.3

Replacing an expansion card in the riser module

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
Preliminary steps
▶
"Locating the defective server" on page 47
▶
"Suspending BitLocker functionality" on page 107
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
▶ Remove all external cables from the expansion card to be replaced.
▶
"Removing the riser module" on page
Removing the expansion card
▶ Remove the expansion card, see
module" on page
▶ If the slot bracket on the defective expansion card is to be used again:
"Removing a slot bracket" on page
TX2550 M5
"Removing an expansion card from a riser
366.
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 10 minutes
49.
50.
51.
48.
86.
329.
369