Removing The System Board; Disconnecting The Cables - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

System board and components

15.4.1.3 Disconnecting the cables

Ê Disconnect all cables from the system board:
– Two power cables of power supply
– Fan/ODD power cable
– Front panel cable
– Power cable for SAS/SATA backplane
– 2x or 4x SATA cables for SAS/SATA backplane
– SATA cable for ODD (if applicable)
– CSS cable (if applicable)
– Front VGA cable (if applicable)
– SGPIO cable (if applicable)
For the cable plan see section

15.4.1.4 Removing the system board

Figure 257: Position of the screws
Ê Remove the eight screws from the system board.
378
"Cabling" on page
Upgrade and Maintenance Manual
462.
RX100 S7