System board and components
15.2.1.5 Installing the riser module 2
Figure 240: Installing the riser module 2
Ê Insert the two riser cards into the system board slots.
Ê If necessary, connect the cables to the other components.
15.2.1.6 Concluding steps
Ê Perform the following procedures:
1.
"Closing the server" on page 66
2.
"Installing the server in the rack" on page 68
3.
"Enabling SVOM boot watchdog functionality" on page 89
4.
"Switching on the server" on page 72
5.
"Enabling BitLocker functionality" on page 94
6.
"Closing the rack door" on page 73
15.2.1.7 Software configuration
The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server.
354
Upgrade and Maintenance Manual
RX100 S7