Disconnecting The Bbu Cable From The Raid Controller; Installing The Riser Module 2; Concluding Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.3.7

Disconnecting the BBU cable from the RAID controller

Figure 164: Disconnecting the BBU cable from the RAID controller
Ê Disconnect the BBU cable from the RAID controller.
9.5.3.8

Installing the riser module 2

Ê Install the riser module 2 as described in section
2" on page 207.
9.5.3.9

Concluding steps

Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Switching on the server" on page 72
4. "Closing the rack door" on page 73
254 Upgrade and Maintenance Manual
"Installing the riser module
RX100 S7