Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual page 382

System board and components
7. Install all expansion cards see section
modules" on page
I
Make sure that you reinstall each card in the slots it was located
before the replacement.
8. "Closing the server" on page 66
9. "Installing the server in the rack" on page 68
10. Connect all external cables.
11. "Updating the system board BIOS and iRMC" on page 81
12. If applicable, activate TPM functionality in the system BIOS under
Security > TPM (Security Chip) Setting > Security Chip. For more
information, refer to the "D3034 BIOS Setup Utility for PRIMERGY
RX100 S7 Reference Manual".
13. "Verifying system information backup / restore" on page 83
14. If customer BIOS settings are not restored automatically, please change
the settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and password.
V
CAUTION!
The system event log entry Chassis IDPROM: Restore
successful (see section
backup / restore" on page
system board BIOS from version 1.15.0 or below to version 1.18.0
or above.
15. "Verifying the system time settings" on page 91
16. "Looking up changed MAC / WWN addresses" on page 96
17. "Updating the NIC configuration file in a Linux environment" on page 93
18. "Enabling SVOM boot watchdog functionality" on page 89
19. "Switching on the server" on page 72
20. "Enabling BitLocker functionality" on page 94
382
199.
Upgrade and Maintenance Manual
"Expansion cards and riser
"Verifying system information
83) is not valid if you updated the
RX100 S7