Connecting The Cables; Concluding Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

7.2.5.6

Connecting the cables

Figure 84: Connecting the cables to the 3.5-inch SAS/SATA backplane
Ê Connect the following cables to the SAS/SATA backplane:
– (1) power cable to connector J4
– (2) SGPIO cable to connector J2
– (3), (4) SAS/SATA data cables to connectors SATA1, SATA2 according
the color coding
For the cable plan see section
7.2.5.7

Concluding steps

Ê Perform the following procedures:
1. Insert all HDD modules, see section
on page 162.
I
Make sure that you reinstall the HDD module in the bay it was
located before the SAS/SATA backplane replacement.
2. "Closing the server" on page 66
3. "Installing the server in the rack" on page 68
4. "Switching on the server" on page 72
5. "Closing the rack door" on page 73
RX100 S7
"Cabling" on page
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
462.
"Installing the 3.5-inch HDD module"
171