Replacing An Expansion Card From A Riser Module - Fujitsu PRIMERGY RX4770 M6 Upgrade And Maintenance Manual

Expansion cards and backup units
Concluding steps
▶ Install the corresponding riser module, see
page 63.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If
applicable,"Installing the front cover with lock" on page
▶
"Resuming BitLocker functionality" on page
9.7.3

Replacing an expansion card from a riser module

Upgrade and Repair Unit
(URU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
When replacing network controllers, network configuration settings in
the OS will be lost and replaced by default values. This applies to all
static IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing a
controller.
Preliminary steps
▶
"Locating the defective server" on page 97
▶
"Suspending BitLocker functionality" on page
▶ If
applicable,"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
212
53.
59.
60.
46.
Upgrade and Maintenance Manual
"Installing a riser module" on
61.
104.
Hardware: 10 minutes
Software: 5 minutes
81.
47.
45.
RX4770 M6