Hard Disk Drives / Solid State Drives - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

7 Hard disk drives / solid state
drives
The hard disk drives or solid state drives which can be ordered for the
PRIMERGY RX100 S7 are supplied already mounted in an installation frame so
that defective drives can be replaced and new drives can be added during
operation. The hard disk drive or solid state drive and the installation frame
together make up the HDD module or SSD module.
The server is shipped with one of the following HDD or SSD subsystems:
– 3.5-inch HDD subsystem:
Up to two 3.5-inch SAS/SATA HDD modules can be installed. Each HDD
module can accommodate an SAS/SATA hard disk drive with a maximum
height of 1 inch. The HDD module is connected to the SAS/SATA backplane
wirelessly. This allows HDD modules to be plugged in or pulled out easily.
Hybrid configurations of SAS and SATA HDD modules are not supported.
– 2.5-inch HDD/SSD subsystem:
Up to four 2.5-inch SAS/SATA HDD/SSD modules can be installed. Each
HDD/SSD module can accommodate a SAS/SATA hard disk drive or SATA
solid state drive with a 2.5-inch format. The HDD/SSD modules are
connected to the SAS/SATA backplane wirelessly. This allows HDD/SSD
modules to be plugged in or pulled out easily. If the server has a
corresponding RAID configuration, defective HDD/SSD modules can also
be replaced during operation.
Hybrid configurations of SAS and SATA HDD/SSD modules are not
supported.
RX100 S7
Upgrade and Maintenance Manual 143