Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual page 140

Power supply
Figure 63: Installing the power supply module
Ê Carefully push the power supply module into the empty bay (1) until it stops.
Ê Push the handle of the power supply module as far as it will go in the
direction of the arrow (2).
I
Make sure that the power supply module engages correctly in the bay
and is locked in position. This is the only way to prevent the power supply
unit from sliding out of its bay and being damaged during transportation.
Ê If a second power supply module has been installed before, install this one
in the same way.
140 Upgrade and Maintenance Manual
RX100 S7