Removing The Processor From The Defective System Board; Installing The Processor On The New System Board; Installing The New System Board - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

System board and components

15.4.1.6 Removing the processor from the defective system board

Ê Remove the processor (see section
page 284).
Ê Remove the protective plastic cover from the processor socket of the new
system board and fit it onto the socket of the defective system board which
will be sent back to spares.
I
Returned system boards without this cover probably have to be
scrapped.

15.4.1.7 Installing the processor on the new system board

Ê Install the processor (see section
page 286).
Ê Check the settings on the new system board (see section
board" on page

15.4.1.8 Installing the new system board

Figure 259: Inserting the system board
Ê Insert the system board by holding it at a slight angle. Slide the connectors
into the connector panel.
380
459).
Upgrade and Maintenance Manual
"Removing the defective processor" on
"Installing the new processor" on
"Settings system
RX100 S7