Required Tools; Preliminary Steps; Removing The Riser Module 2 - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

System board and components

15.2.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Main steps: Phillips PH1 / (+) No. 1 screw driver
●

15.2.1.2 Preliminary steps

Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Disabling SVOM boot watchdog functionality" on page 76
3. "Disabling BitLocker functionality" on page 75
4. "Shutting down the server" on page 59
5. "Extending/removing the server from the rack" on page 60
6. "Opening the server" on page 64

15.2.1.3 Removing the riser module 2

Figure 237: Removing the riser module 2
Ê Carefully pull out the riser module 2 upward.
352 Upgrade and Maintenance Manual
RX100 S7