Replacing The 2.5-Inch Sas/Sata Backplane; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

7.1.5

Replacing the 2.5-inch SAS/SATA backplane

Field Replaceable Units (FRU)
Average task duration: 10 minutes
V
CAUTION!
Follow the safety instructions in chapter
page 43.
7.1.5.1

Required tools

Preliminary and concluding steps: tool-less
●
Main steps: tool-less
●
7.1.5.2

Preliminary steps

Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
6. Release all HDD/SSD modules and pull them out a few centimeters, see
section "Removing the 2.5-inch HDD/SSD module" on page 151
I
The HDD/SSD modules need not to be removed. But if you want
to remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
RX100 S7
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Important information" on
155