Power supply
6.1.1.6
Connecting the power cables
Figure 20: Connecting the power cables
Ê Connect the two power cables to the system board connectors "PWR2" and
"PWR1".
6.1.1.7
Concluding steps
Ê Perform the following procedures:
1.
"Closing the server" on page 66
2.
"Installing the server in the rack" on page 68
3.
"Switching on the server" on page 72
4.
"Enabling BitLocker functionality" on page 94
5.
"Performing a fan test after replacing a defective fan" on page 99
6.
"Closing the rack door" on page 73
V
CAUTION!
(Except for Japanese market) After replacing the standard power
supply unit a fan calibration must be started for the PSU fan. You will
find the description for this procedure in the manual "ServerStart".
106
Upgrade and Maintenance Manual
RX100 S7