Removing The Power Cord; Preliminary Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Power supply
6.3.2.2

Preliminary steps

Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. Only when replacing a power supply module in a non-redundant
configuration:
4. "Locating the defective component" on page 58
5. Check which power supply module is defective.
A power supply module is defective when the indicator (1) in
lights orange. For more information see section
indicators" on page
6.3.2.3

Removing the power cord

Figure 45: Removing the power cord
Ê Open the cable tie.
Ê Remove the power cord from the power supply module.
126
"Shutting down the server" on page 59
447.
Upgrade and Maintenance Manual
figure 44
"Connectors and
RX100 S7