Replacing A Gpu Card From A Riser Module - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

▶ Install the two slot covers.
Concluding steps
▶
"Installing the crossbar" on page
▶
"Installing the air duct" on page
▶ If applicable, install the corresponding riser module, see
module" on page
▶ If applicable, install the corresponding rear air grid, see
grid" on page 87.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
▶ If applicable, update the system information of your server using the Chassis
ID Prom Tool, see
▶
"Resuming BitLocker functionality" on page
9.7.3

Replacing a GPU card from a riser module

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
When replacing network controllers, network configuration settings in
the OS will be lost and replaced by default values. This applies to all
static IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing a
network controller.
RX2540 M7
84.
79.
74.
59.
71.
"Using the Chassis ID Prom Tool" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
65.
107.
Hardware: 10 minutes
Software: 5 minutes
"Installing a riser
"Installing a rear air
71.
113.
293