Installing The New Ufm; Installing The Riser Module 2; Concluding Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

System board and components

15.2.3.6 Installing the new UFM

Figure 246: Installing the UFM
Ê Connect the UFM to the system board and the remaining UFM spacer (1).
Ê Fasten the UFM to the UFM spacer with the nylon screw (2).

15.2.3.7 Installing the riser module 2

Ê Install the riser module 2 as described in section
2" on page 354.

15.2.3.8 Concluding steps

Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Enabling SVOM boot watchdog functionality" on page 89
4. "Switching on the server" on page 72
5. "Enabling BitLocker functionality" on page 94
6. "Closing the rack door" on page 73
360 Upgrade and Maintenance Manual
"Installing the riser module
RX100 S7