Concluding Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.5.7

Concluding steps

Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Enabling replaced components in the system BIOS" on page 89
4. "Updating RAID controller firmware" on page 84
5. "Enabling SVOM boot watchdog functionality" on page 89
6. "Switching on the server" on page 72
7. "Enabling BitLocker functionality" on page 94
8. "Closing the rack door" on page 73
9. After replacing a network controller in a server running Linux OS,
"Updating the NIC configuration file in a Linux environment" on page
10. If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller
(expansion card or onboard).
The following notes are required for RX100 S7p (PYR10Pxxx for
Japanese market).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section
network settings recovery" on page
11. If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
12. Inform the customer about changed WWN and MAC addresses, see
"Looking up changed MAC / WWN addresses" on page
220 Upgrade and Maintenance Manual
217.
98.
93.
"Note on
"After replacing /
96.
RX100 S7