Preliminary Steps; Removing The Riser Module 1 - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.5.2

Preliminary steps

Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. If applicable, ensure to note down your current network settings in the
operating system.
4. "Disabling SVOM boot watchdog functionality" on page 76
5. "Disabling BitLocker functionality" on page 75
6. "Shutting down the server" on page 59
7. "Extending/removing the server from the rack" on page 60
8. "Opening the server" on page 64
9. "Locating the defective component" on page 58
9.4.5.3

Removing the riser module 1

Ê Remove the riser module 1 as described in section
module 1" on page
218
209.
Upgrade and Maintenance Manual
"Removing the riser
RX100 S7