Replacing Sas / Sata Hdd / Ssd Backplanes; Replacing The 2.5-Inch Hdd Sas / Sata Backplane; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

7.4 Replacing SAS / SATA HDD / SSD
backplanes
7.4.1

Replacing the 2.5-inch HDD SAS / SATA backplane

Field Replaceable Units (FRU)
Average task duration: 10 minutes
7.4.1.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the SAS backplane:
●
– Phillips PH2 / (+) No. 2 screw driver
7.4.1.2

Preliminary steps

I
The 2.5-inch HDD SAS / SATA backplane is mounted on the drive cage.
It is not necessary to remove the drive cage before replacing the
SAS / SATA backplane
Before replacing a 2.5-inch HDD SAS / SATA backplane, perform the following
steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
TX140 S1
93.
61.
54.
61.
"Disconnecting power cords" on page
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Disabling BitLocker
"Locating the defective
"Opening the rack
"Shutting down the
63.
185