Configuring Dc Power On A T4000 Router (Five 60-A Cables On A Six-Input Dc Power Supply); Configuring Dc Power On A T4000 (Four 60-A Cables On A Six-Input Dc Power Supply); Configuring Dc Power On A T4000 - Juniper T4000 Hardware Manual

Configuring DC Power on a T4000 Router (Five 60-A Cables on a Six-Input DC Power Supply)

Configuring DC Power on a T4000 (Four 60-A Cables on a Six-Input DC Power Supply)

Copyright © 2013, Juniper Networks, Inc.
For more information about configuring the DC power supply and the commands used
in the procedures, see the T4000 Power Management Overview in the Junos OS
Administration Library for Routing Devices.
Configuring DC Power on a T4000 Router (Five 60-A Cables on a Six-Input DC Power
Supply) on page 149
Configuring DC Power on a T4000 (Four 60-A Cables on a Six-Input DC Power
Supply) on page 149
Configuring DC Power on a T4000 (Three 80-A Cables on a Six-Input DC Power
Supply) on page 150
When you connect five cables on a six-input DC power supply, you must specify the
number of input feeds connected in the software. If the number of physical input feeds
receiving power does not match the number of configured input feeds, the router displays
an alarm message.
Configure the number of input feeds to indicate that five DC power cables are
1.
connected.
[edit]
user@host# set chassis pem feeds 5
NOTE: The default number of input feeds is 6.
(Optional) Use the
2. show
correct.
[edit]
user@host# show
pem {
feeds 5;
}
Commit the configuration to activate it on the router, and exit configuration mode.
3.
[edit]
user@host# commit
user@host# exit
user@host>
When you connect four cables on a six-input DC power supply, you must specify the
number of input feeds connected in the software. If the number of physical input feeds
receiving power does not match the number of configured input feeds, the router displays
an alarm message.
Configure the number of input feeds to indicate that four DC power cables are
1.
connected.
[edit]
statement to display the configuration to verify that it is
Chapter 14: Configuring Junos OS
149