Management Interfaces; Configuring Management Interfaces - Dell S4048–ON Configuration Manual

Management Interfaces

The system supports the Management Ethernet interface as well as the standard interface on any port. You can use either method to
connect to the system.

Configuring Management Interfaces

The dedicated Management interface provides management access to the system.
You can configure this interface using the CLI, but the configuration options on this interface are limited. You cannot configure Gateway
addresses and IP addresses if it appears in the main routing table of Dell Networking OS. In addition, proxy ARP is not supported on this
interface.
To configure a management interface, use the following commands.
• Enter the slot and the port (1) to configure a Management interface.
CONFIGURATION mode
interface managementethernet interface
The slot range is 1.
The port range is 1.
• Configure an IP address and mask on a Management interface.
INTERFACE mode
ip address ip-address mask
• ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in /prefix format (/x).
Viewing Two Global IPv6 Addresses
Important Points to Remember — virtual-ip
You can configure two global IPv6 addresses on the system in EXEC Privilege mode. To view the addresses, use the show interface
managementethernet command, as shown in the following example. If you try to configure a third IPv6 address, an error message
displays. If you enable auto-configuration, all IPv6 addresses on that management interface are auto-configured. The first IPv6 address that
you configure on the management interface is the primary address. If deleted, you must re-add it; the secondary address is not promoted.
The following rules apply to having two IPv6 addresses on a management interface:
• IPv6 addresses on a single management interface cannot be in the same subnet.
• IPv6 secondary addresses on management interfaces:
• across a platform must be in the same subnet.
• must not match the virtual IP address and must not be in the same subnet as the virtual IP.
Dell#show interfaces managementethernet 1/1
ManagementEthernet 1/1 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:01:e8:a0:bf:f3
Current address is 00:01:e8:a0:bf:f3
Pluggable media not present
Interface index is 302006472
Internet address is 10.16.130.5/16
Link local IPv6 address: fe80::201:e8ff:fea0:bff3/64
Global IPv6 address: 1::1/
Global IPv6 address: 2::1/64
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
400 Interfaces