Upgrade Wm-1 From V4R1 Gp7 To V5R3; Manually Move Aps Back To Local Wm; Upgrading From Any Past Release Less Than V4R1 Gp7 Release; Upgrading From V1R0 Gp1/Gp2/Gp3/Gp4 To V5R3 Release - Extreme Networks Summit WM Maintenance Manual

Upgrade WM-1 from V4R1 GP7 to V5R3

If the WM-1 controller is a WM100/1000 and requires to be replaced by a WM200/2000 controller, you
must follow the procedure described in
If the WM-1 controller is a WM200/2000 platform, use the standard procedures – the GUI or the CLI –
to carry out the upgrade.
When you upgrade the WM-1 controller, it will reboot. Consequently, the "Availability" feature moves
all the four APs from WM-1 to WM-2. Since the WM-2 was upgraded to V5R3, all the four APs are
upgraded as well. This will cause a short disruption of service. All the clients on all 4 APs remain
disconnected. They re-connect automatically (if configured to do so) after the service is restored.
Both controllers are now upgraded to V5R3 release, and have the same configuration as before. All the
four APs are also upgraded to V5R3 release.

Manually move APs back to Local WM

Manually move AP-1 and AP-2 from WM-2 to WM-1, where they were configured as 'Local' APs. This
brings the network back to the original configuration with each controller running two APs.
Upgrading from any past release less than V4R1 GP7
release
The topics in this section are divided into the following sections:

Upgrading from V1R0 GP1/GP2/GP3/GP4 to V5R3 release

●
Upgrading from V1R0 GP5 or higher to V5R3 release
●
Upgrading from V1R1 GPx (Any GP) to V5R3 release
●
Upgrading from V1R0 GP1/GP2/GP3/GP4 to V5R3 release
To upgrade from V1R0 GP1/GP2/GP3/GP4 to V5R3:
1 Install V1R0 GP5 release.
NOTE
The complete version number of GP5 is 1.0.2.05.01.
2 Install V1.1 OS upgrade (AC-3_1_7).
3 Install V1R1 GP15.
NOTE
The complete version number of GP15 is 1.1.5.15.02.
Summit WM Maintenance Guide, Software Version 5.3
"Migrating the platform configuration" on page 30.
35