Enable Dot1P Replacement Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

QoS Commands

enable dot1p replacement ports

enable dot1p replacement ports [<port_list> | all]
Description
Allows the 802.1p priority field to be overwritten on egress according to the QoS profile to 802.1p
priority mapping for a given set of ports.
Syntax Description
port_list
all
Default
N/A.
Usage Guidelines
The dot1p replacement feature is disabled by default.
By default, 802.1p priority information is not replaced or manipulated, and the information observed on
ingress is preserved when transmitting the packet.
NOTE
The port in this command is the ingress port.
If 802.1p replacement is enabled, the 802.1p priority information that is transmitted is determined by the
hardware queue that is used when transmitting the packet.
NOTE
This command affects only that traffic in traffic groupings based on explicit packet class of service
information and physical/logical configuration.
Example
The following command enables dot1p replacement on all ports:
enable dot1p replacement ports all
History
This command was available in ExtremeWare XOS 11.0.
298
Specifies a list of slots and ports. May be in the form 3-5, 2:5, 2:6-2:8.
Specifies that dot1p replacement should be enabled for all ports.
ExtremeWare XOS 11.0 Command Reference Guide