Recall Timer - Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
4 Features
System Features
Planning Form Instructions
Under the Calls to Unassigned Extensions heading on Form 8a, do one of the
following:
To keep the factory setting, check the Extension box.
To change from the factory-set redirect to the primary operator, check one
of the following:

Recall Timer

This section contains instructions for designating the length of the switchhook
flash sent when Recall is used to disconnect a call and receive a new dial tone
without hanging up. The interval of the switchhook flash and how Recall works
depends on the type of telephone being used.
For multiline telephones, the factory setting is 450 ms. If users experience
difficulty with Recall, the interval can be changed to a longer or shorter interval.
The single-line telephone Flash or Recall button transmits a timed switchhook
flash of about half a second.
Planning Form Instructions
Under the Recall Timer heading on Form 8a, check one of the following:
350 ms
450 ms (factory setting)
650 ms
1 sec
— To redirect calls to a QCC operator (Hybrid/PBX only), check the
QCC queue box and write the extension number in the space
provided (see Form 2a).
— To redirect calls to another telephone, check the Extension box and
write the extension number in the space provided (see Form 2a).
— To redirect calls to a calling group, check the Calling Group box and
write the calling group extension number in the space provided (see
Form 7d).
4
Issue 1
April 1999
4-48
4
4