Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 159

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Selecting Line/Trunk Options
4. For all B-channel groups you plan to assign to Dial Plan Routing, you must
program the Dial Plan Routing table to direct the system to properly route
calls. Record table entries (maximum: 16 entries) on Form 3b (page 6):
a.
b.
c.
d.
5. In the Network Selection Table of the outgoing tables on Form 3b (page 7),
the dial pattern represents the dial code for specifying a long-distance
common carrier; the asterisks represent the digits in the common carrier
NOTE:
The factory does not preassign a telephone number. The telephone
number you assign should be the same sent to the system by the
network. The number should also be unique within the same
B-channel group and must be different from the associated test
telephone number. (Test telephone numbers are assigned later in
this procedure.)
For the entry to be activated, a service must be entered. In the
Service cell, write one of the following:
. (for 4ESS or 5ESS, see Form 3b, page 1)
Megacom WATS, Megacom 800, ACCUNET SDS, Software
Defined Network (SDN), MultiQuest, and Long Distance.
. (For switch type 5ESS, see Form 3b, page 1)
OUTWATS, 56/64 Digital, Virtual Private Network, and
INWATS.
. (for DMS-250 or DEX600E, see Form 3b, page 1)
MCI Prism, MCI VNet, and MCI 800 and MCI 900.
DMS Private Network, DMS INWATS (Inward Wide Area
Telephone Service), DMS OUTWATS (Outward Wide Area
Telephone Service), DMS FX (Foreign Exchange), and DMS
Tie Trunk.
. Call-by-Call and Other.
In the Pattern to Match cell, write the exact pattern to match if you
have more than one block of incoming numbers. If you want to
match any pattern, leave it blank.
In the Total Digits in Dialed Number cell, write the total number of
digits (0 14) expected in the dialed number; 0 is a wildcard (match
any number). (Contact the service provider for the appropriate
number.)
After the match has been made, do either of the following to enable
the system to determine where to direct the call:
To delete digits, write the number of digits to delete (0 14).
(The system deletes from the first digit forward.)
To add digits, write the exact digits to enter (up to four digits)
as a prefix—for example,
(The system adds the digits to the beginning of the number.)
. (for a DMS-100, see Form 3b, page 1)
. The factory setting is blank.
Issue 1
April 1999
3-37