Forced Account Code Entry - Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
4 Features
Telephone and Extension Features
Planning Form Instructions
If these restrictions are too limited, use
described later in this chapter.
Use Form 6h to identify Authorization Codes for use by the users of certain
extensions. After you complete Form 6h, remove it from the forms set and keep it
in a secure place.
Use Form 6g, Call Restriction Assignments and Lists, to identify the extensions
with calling restriction assignments. List the extensions with calling restrictions in
the Ext. No. column and the type of restriction in the Restriction Type column. The
factory setting is Restricted.
NOTE:
Setting this option to Outward Restrict or Toll Restrict does not allow
reliable toll restriction on telephone company lines/trunks that do not
require 1 or 0 for toll calls. The Toll Type setting of 1 or 0 allows the system
to classify calls as either local or toll, based on the number a user dials.
Dialing a prefix depends on local telephone company requirements and the
type of trunk being used. The system must be programmed to designate
whether or not to restrict users from dialing calls to certain areas. The Toll
Type feature does not apply to DID trunks or private network tandem
trunks.
To restrict the extension from making outside calls so only intercom or private
network calls can be made, check the Outward Restriction column.
To restrict the extension from making toll calls so only intercom, local, or private
network calls can be made, check the Toll Restriction column.

Forced Account Code Entry

This section contains instructions for setting up the system to associate calls with
corresponding accounts, clients, or projects for billing and accounting purposes.
Planning Form Instructions
Use Form 6b to identify extensions requiring Forced Account Code Entry. Under
the Forced Account Code Entry heading on Form 6b, do either of the following:
To allow users to make calls without entering an account code, check the
No (factory setting) box.
To require users to enter an account code, check the Yes box.
''Allowed Lists'' and ''Disallowed
4
Issue 1
April 1999
4-5
4
Lists," as
4