Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 117

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
2 Control Unit Configuration
Numbering the System
4. If the system has Messaging 2000 or AUDIX Voice Power, also write
in the Appl column for any logical IDs that are being used for fax ports.
5. If the system is to be part of a Centralized Voice Messaging system
(Release 6.1 and later systems only), check Yes under the Centralized
Voice Messaging heading. Also check Yes on page 4 of the MERLIN
LEGEND R6 Design Implementation Guide form located in Appendix I. If it
will not be part of a Centralized Voice Messaging system, check No on both
forms.
6. For each 016 (T/R) module, if applicable, indicate the Ringing Frequency
for that module. Enter
ports on the 016 (T/R) module. When configuring a system in the United
States or Canada, generally the 20-Hz setting is applicable. The factory
setting is 20-Hz.
7. If you are using rotary-dial equipment, check the Rot. Dial column to
indicate that Rotary Dial Enable is to be activated (Release 7.0 and later
systems).
Proceed to the next section, ''Labels."
Labels
This section contains instructions to associate alphanumeric labels with extension
numbers so that both the name of the caller and the extension number appear on
display telephones.
Planning Form Instructions
On the appropriate line in the Label column on Form 2a, write the label
(maximum: 7 characters) to be displayed for each telephone.
NOTE:
For more information on Centralized Voice Messaging, see the
Network Reference .
or in the Ring Freq. column for all
2
Issue 1
April 1999
2-35
2