Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 314

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
6 Modifications
Adding to the System
Do either of the following:
5.
6. Revise or complete the required planning form or forms according to the
directions shown in
7. If you rearrange modules in the control unit, the numbering plan reverts to
the factory-set 2-digit plan. You must then reprogram the system:
a.
b.
c.
d.
NOTE:
Placing additional modules in the control unit requires a recalculation
of unit loads. See Appendix F, "Unit Load Calculation."
If the control unit has an available slot to the right, and the
guidelines permit placement there, proceed to Step 6.
If you must rearrange existing modules to accommodate the
new one, skip to Step 7.
Table 6-1,
Obtain a blank set of planning forms; copy them from Appendix B of
this book or order them separately.
Locate the Equipment List (if available), the local telephone
company line/trunk information list, the floor plan, and the Employee
Communication Survey forms. If any of these materials has been
revised, find both the original and revised versions.
Work through System Planning , beginning with
Unit Configuration."
When you have completed modifying existing forms or completing
new forms, program the modification or modifications, following the
instructions in System Programming.
Table 6-2, and Table
Issue 1
April 1999
6-3.
Chapter 2, ''Control
6-4