Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 197

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Assigning Telephone Buttons
Decide which lines/trunks should appear on each DLC operator console based on
each operator's call-handling responsibilities. All operators may not need the
same assignments. DLC operators who are responsible for answering calls for
specific groups usually need only the lines/trunks used by group members.
If the system includes a loudspeaker paging system, consider assigning a
programmed Loudspeaker Paging button to DLC positions for one-touch access
to the paging equipment. If the system has fewer than 30 lines, the operator-only
features (Alarm, Night Service, and Send/Remove Messages) are factory-
assigned as shown in
through centralized telephone programming or by a DLC operator.
Planning Form Instructions
Complete the Button Diagram page on each copy of Form 5a and Form 5b:
1. For the Ring and Voice buttons, circle SA or Icom.
2. Write the telephone number of the line/trunk you want to assign in the
space on the Button Diagram page. Record each line/trunk number (see
Form 2c).
3. Assign Alarm, Night Service, or Send/Remove Message buttons by
labeling the appropriate button
4. Assign programmed Loudspeaker Paging buttons by selecting the button
and writing
Proceed to
forms.
Figure 3-27. The factory assignments can be changed
on it.
Chapter 4, ''Features," to complete the remaining sections of these
, , or
Issue 1
April 1999
3-75
3
.