Assigning Pools And Lines/Trunks (Hybrid/Pbx Mode Only) - Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
5 Data Communications
Assigning Lines/Trunks to Data and Video Stations
The factory settings can be changed; however, the settings should be adequate to
meet most user needs, since System Access lines can be used to make both
inside and outside data calls. Each data extension must have at least one SA
button, or two SA buttons for making 2B Data calls. If making 2B Data calls with
two personal line buttons, you must also have two SA buttons.
If you want an ISDN terminal adapter data station to make and receive outside
data calls on a specific outside line/trunk, assign a personal line button. To make
calls on a personal line, set the Automatic Line Selection to that line.
Assigning Pools and Lines/Trunks
(Hybrid/PBX Mode Only)
If you want the voice and data station to make and receive outside calls on a
specific trunk pool, assign a Pool button.
To dedicate a specific line/trunk or pool to receive outside data calls, assign a
personal line or pool to a data station or DHG.
To dedicate specific lines/trunks for use in data communications only (such as PRI
channels or other special data lines), consider grouping those lines/trunks in a
pool.
If the system uses ARS, follow the instructions on ARS earlier in this book to
specify routes for outgoing data calls.
To restrict non-data users from dial access to data trunk pools, use the
Out Code (Hybrid/PBX Mode Only)''
Forms Needed
Form 2c, System Numbering: Line/Trunk Jacks
Data Form 1a, Modem Data Station
Data Form 1b, ISDN Terminal Adapter Data Station
Planning Form Instructions
Record your decisions for each data station on the Hybrid/PBX Mode Button
Diagram of Data Form 1a or 1b.
1. If you want to assign personal lines to the data station, write
and the telephone number (from Form 2c) of the outside line on the
appropriate button. For ISDN terminal adapter data stations, include the
line/trunk number.
2. If you want to assign a pool to the data station, write
extension number (from Form 2c) on the appropriate button.
5
instructions later in this chapter.
Issue 1
April 1999
5-31
''Pool Dial-
5
5
and the pool's