Set System Date; Backup - Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
2 Control Unit Configuration
Recording System Operating Conditions
Planning Form Instructions
Under the Automatic Maintenance Busy heading in the System Operating
Conditions section of Form 1, page 2, do either of the following:
To keep the factory setting (no maintenance-busy state), check Disable.
To enable Automatic Maintenance Busy, check Enable.

Set System Date

The system date is the month, day, and year, shown on display telephones and
SMDR reports. For information on SMDR, see
Error reports used by authorized technicians for maintenance also show the
system date and time.
These sections on the planning form remind you to set the system date when you
perform the initial programming for the system.
Planning Form Instructions
Check Yes under the Set System Date heading on Form 1 as a reminder to set
the current date.

Backup

Backup makes a copy of the customized system data on a translation memory
card. A backup is made after each system upgrade, service technician visit, or
major system reconfiguration.
NOTE:
If Automatic Backup is used, the customer must ensure that a valid
PCMCIA Translation card is in the processor slot at the time of the backup.
Otherwise, the Automatic Backup feature will be canceled and the
customer must reset it.
Planning Form Instructions
Check Automatic if weekly or daily backup procedures are planned. Record the
day and time in the blank space for weekly backups or the time of day for daily
backups.
Check Manual if you plan manual backup procedures.
2
''System Features''
2
Issue 1
April 1999
2-11
2
in Chapter 4.
2
2