Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 161

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Selecting Line/Trunk Options
c.
d.
8. On Form 3b, check the appropriate box for the information that will be sent
to the network for outgoing PRI calls. Check Extension Only, Base Number
with Extension, or Line Telephone Number.
If you check Line Telephone Number, do the following:
9. If available, assign a test telephone number that is used for maintenance
by the service provider. For each 100D module with a PRI service type,
write the test telephone number (up to 12 digits) used for maintenance next
to the module number under the Test Telephone Numbers heading on
Form 3b (page 10).
In the Service cell, write one of the following:
. (for 4ESS or 5ESS, see Form 3b, page 1)
Megacom WATS, Megacom 800, ACCUNET SDS, Software
Defined Network (SDN), MultiQuest, and Long Distance.
. (For switch type 5ESS, see Form 3b, page 1)
OUTWATS, 56/64 Digital, Virtual Private Network, and
INWATS.
. (for DMS-250 or DEX600E, see Form 3b, page 1)
MCI Prism, MCI VNet, and MCI 800 and MCI 900.
DMS Private Network, DMS INWATS (Inward Wide Area
Telephone Service), DMS OUTWATS (Outward Wide Area
Telephone Service), DMS FX (Foreign Exchange), and DMS
Tie Trunk.
. Call-by-Call and Other.
If the system will need to delete digits, write the number of digits to
delete (0 8). (The system deletes from the first digit onward.)
Identify the trunk number.
Write the telephone number (up to 12 digits) that identifies the
company as the caller in the Telephone Number to Send column.
NOTE:
There is no factory-assigned telephone number. If you
assign a number, it does not have to be unique. Also, the
availability of caller identification information may be limited
by your local-serving jurisdiction, by availability, or by central
office equipment.
. (for a DMS-100, see Form 3b, page 1)
Issue 1
April 1999
3-39