Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 158

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Selecting Line/Trunk Options
c.
d.
3. For all B-channel groups that are programmed to route calls by line
appearance, assign a telephone number to each line in the B-channel
group. Record the information on Form 3b (page 5):
a.
b.
Write the services to be associated with each group under the
Outgoing Services and Incoming Services headings. Select from the
following services:
. (for 4ESS or 5ESS, see Form 3b, page 1)
Megacom WATS, Megacom 800, ACCUNET SDS, Software
Defined Network (SDN), MultiQuest, and Long Distance.
. (For switch type 5ESS, see Form 3b, page 1)
OUTWATS, 56/64 Digital, Virtual Private Network, and
INWATS.
. (for DMS-250 or DEX600E, see Form 3b, page 1)
MCI Prism, MCI VNet, and MCI 800 and MCI 900.
DMS Private Network, DMS INWATS (Inward Wide Area
Telephone Service), DMS OUTWATS (Outward Wide Area
Telephone Service), DMS FX (Foreign Exchange), and DMS
Tie Trunk.
. Call-by-Call and Other.
NOTE:
If a B-channel group has more than one outgoing service,
then enter Call-by-Call on Form 3b, page 4, under the
Outgoing column instead of itemizing the services. Form 3b,
page 8, is where you enter specific services with specific
dial-out patterns.
If the group has incoming services assigned, do either of the
following:
If the routing will be Dial Plan Routing (Hybrid/PBX mode
only), check Dial Plan Routing.
If the routing will be by line appearance, check Line
Appearance.
Write the B-channel group numbers and the trunk number or
numbers from Form 3b (page 3).
In the Telephone Number column, write the unique inbound routing
telephone number (the "directory number") of up to 12 digits,
furnished by the PRI service provider.
. (for a DMS-100, see Form 3b, page 1)
Issue 1
April 1999
3-36