Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 167

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Selecting Line/Trunk Options
!
CAUTION:
Since the system can have only two blocks of DID trunks, when configuring
a private network, careful planning of both immediate and future needs is
essential when ordering DID trunks from the local telephone company. See
the Network Reference for additional information.
Planning Form Instructions
On Form 3d, under the Type heading, do either of the following:
1.
2. Under the Expected Digits heading on Form 3d, do either of the following:
3. Compare the number of digits sent by the local telephone company to the
number of digits in the system numbering plan, and do one of the following:
4. Under the Signaling heading, do either of the following:
To keep the factory setting, check the Wink-Start box.
To change the type, check the Immediate-Start box.
To show that the telephone company sends the factory-set number
of digits, check the box labeled 3 .
To show the number of digits sent by the telephone company, check
one of the boxes labeled 1 , 2 , or 4 .
If the system's numbering plan matches the number of digits sent by
the telephone company, check 0 (the factory setting) under the
Delete Digits and Add Digits headings.
If the number of digits sent by the local telephone company is more
than the number of digits in the system numbering plan, specify that
one to four digits be deleted from the telephone company digits by
checking the appropriate number (1, 2, 3, or 4) under the Delete
Digits heading.
If the number of digits sent by the local telephone company is fewer
than the number of digits in the system's numbering plan, specify
the specific digits (1 9999) to be added to the digits sent; check the
Add these digits box under the Add Digits heading and then write
the specific digits to be added in the space provided.
To keep the factory-set signal, check Rotary.
To change the setting, check Touch-Tone. (You cannot have
touch-tone if you selected Immediate-Start.)
Issue 1
April 1999
3-45
3