Using Install; Entering The Install Program - Avaya Octel 200 Installation And Maintenance Manual

1-4 Installation and Maintenance Volume
1.2

USING INSTALL

The customer's specific configuration needs should be determined and a configuration package
completed before the installation begins. Use the configuration package to answer each question in
the INSTALL program. A blank configuration package can be found at the end of the Understanding
Configuration chapter in the Configuration volume.
Follow the directions in the Installation and Maintenance volume, Installation chapter, Terminal
Communications section, to connect your terminal to the OctelR 200/300.

Entering the INSTALL Program

Enter the maintenance level password to access the database. If this is a new installation and the
password has not been changed, enter the maintenance level password set by the manufacturer.
Caution!
At the @ prompt enter:
INSTA or INSTAL
The terminal displays the following messages:
@INSTA
−−−−−−−−
DAY MM/DD/YYYY HH:MM:SS
INSTALL then identifies the type of installation.
New installation.
-
INSTALL question 1 follows.
Installation is in progress.
-
INSTALL can continue, or it can start over.
Message server has previously been installed.
-
To reinstall the message server, you must enter the maintenance password to initiate the reinstall.
The reinstallation begins by erasing all stored information and messages. Do not use
reinstall unless you are prepared to lose all messages.
Octel 200/300 S.4.1
You should change the manufacturer password to
ensure the security of the server. Refer to the
Configuration volume, Understanding Configuration
chapter, Using Security Procedures and Guidelines
section.
Enter
SYSTEM INSTALLATION DIALOG
SYSTEMNAME
−−−−−−−−
ID:XXXXX S/N:XXXXXX PBX:00
PB60019−01