Exiting The Install Program; Modifying Tables While Using Install - Avaya Octel 200 Installation And Maintenance Manual

Exiting the INSTALL Program

When the program is completed, INSTALL displays the following screen:
WARNING: FOR PROPER OPERATION SYSTEM MUST BE RESTARTED AFTER INSTALL!
INSTALL COMPLETE.
WAIT... DONE.
SAVE configuration to a DISKETTE? ( Y/N , empty line = N ).
:
DAY
−−−−−−−−
Answer Y to copy all the data onto the configuration diskette as a backup. The Octel 200/300 must
be reloaded after the INSTALL is complete.
To exit before you have completed the INSTALL program, at the colon (:) type:
.:E
When you type (.E) to exit, the portion of the completed configuration is saved to the hard disk. You
can continue the INSTALL later, from where you left off, or you can start over. Refer to the
Restarting INSTALL section or the Exiting and Continuing section of this chapter.

Modifying Tables While Using INSTALL

While using the INSTALL program, you can access the UPDATE program to list, add, modify, or
delete information in the configuration tables.
The INSTALL program displays a colon (:) when it is waiting for a response. At the colon, type a dot
(.), which is the UPDATE prompt, then an L (list), an A (add), an M (modify), or a D (delete),
followed by the name of the table you want to alter. For example,
:.A USER
The INSTALL program activates the UPDATE program. Alter the tables as necessary. To exit
UPDATE, press
PB60019−01
MM/DD HH:MM:SS YYYY
SYSTEM INSTALLATION COMPLETED
Enter
at the colon. The INSTALL program resumes.
Enter
NAME ID: S/N:
−−−−−−−−
INSTALL 1-5
PBX:
Octel 200/300 S.4.1