Avaya Octel 200 Installation And Maintenance Manual page 155

For maximum configuration, three connector blocks and twelve 25-pair cables are required.
The actual wiring (cross-connections from the 66M4-4W connector block to the 66M block, or
equivalent), can be made in any manner consistent with good telephony practices. Follow these two
guidelines when punching down wires to ensure correct installation:
Do not touch the pins on the connector block with your fingers or with dirty tools. The pins could
-
oxidize and open after a few months.
Tip is always above ring on the block when a pair is punched down.
-
PB60019−01
P6 P1
Octel 200/300
Rear View
Figure 4-10 Example of Server-to-Block Connections
66M4-4W
Installation 4−29
66M4-4W
Octel 200/300 S.4.1