Avaya Octel 200 Installation And Maintenance Manual page 373

Table 7A-2 EVENT and AUX Activities in Call Process Trace Log (continued)
TYPE EVENT
Column Column
Entry Entry
FAX_MSG END_PLAY
FAX_MSG END_PLAY
(continued)
PB60019−01
DESCRIPTION
The playing of the message has ended.
Call Processing Trace Activities
AUX
Column DESCRIPTION
Entry
The CPT shows result codes for fax transactions in the AUX
column. For fax messages, the AUX column is empty if the
fax was successful. The most common result codes listed
are for the END PLAY event.
Fax protocol error
01
Default error code
02
Modem training failure
03
Remote fax requested a feature not
04
supported by the Octel 200/300
Not used
05
Voice bus timeout
06
Fax protocol error
07
VCU software not ready
08
Bad-page-retransmit limit reached
09
Modem connection failure; no response
0A
from on-board modem
Modem connection failure
0B
Other side disconnected
0C
Operator assistance not supported in fax
0D
Fax system ID match
No fax or busy line
0E
0F
Transmitter failed in HDLC test. Used in
10
fax loopback test. Hardware error 63 is
logged
Receiver failed in HDLC test. Used in fax
11
loopback test. Hardware error 63 logged
Both transmitter and receiver failed in
HDLC test. Used in fax loopback test.
12
Hardware error 63 logged
Timeout occurred in HDLC test. Used in
fax loopback test. Hardware error 63
13
logged
No identification frame record from
remote fax
14
Remote fax did not respond to command
Unable to configure remote fax
15
Remote fax did not confirm
Octel 200/300's transmission fax
16
parameters
17
Hardware training failed. No carrier
No response from RX for multipage
signal
18
19
7A-5
Octel 200/300 S.4.1