Floppy Disk Drive Diagnostics - Avaya Octel 200 Installation And Maintenance Manual

The following is an example of the PRTMAP command with ATT75 assigned:
@PRTMAP
SYSTEM
PORT
ID= 0
1
2
3
4
ID= 0
5

Floppy Disk Drive Diagnostics

Use the floppy disk drive (FD) diagnostic command TEST FLOPPY 1 to isolate faults to the disk,
floppy disk drive, or floppy disk controller. To run this test, at the @ prompt, enter:
TE F 1
This test reads the entire disk; if there are errors, the message server responds with the following:
SOFT ERRORS DETECTED
or
FATAL ERROR DETECTED, SEE HARDWARE ERROR TABLE
When the diagnostic is completed, the message server responds as follows:
TEST 01 COMPLETED
If the message server fails to read from or write information to the disk on the first attempt, but is
successful in a subsequent attempt, the message server records a soft error. Soft errors can be caused by
disk wear, contamination on the recording surface, or aging of the floppy disk drive head.
Refer to the Installation chapter for information about the floppy disk write-protect feature.
PB60019−01
SLOT PORT EXTN
1 1 121
1 2 122
1 3 123
1 4 124
2 1 125
Enter
INTEGRATION
SLOT/UNIT
10/1 10/2 11/1 11/2
10/1 10/2 11/1 11/2
10/1
10/2
10/2
Maintenance Commands
6-31
Octel 200/300 S.4.1