Disk Information Status (L Dmap) - Avaya Octel 200 Installation And Maintenance Manual

y
= REGION
@DEX 1
REGION 01 COMPLETE
REGION 02 COMPLETE
REGION 04 COMPLETE
REGION 08 COMPLETE
REGION 10 COMPLETE
DISK EXERCISE COMPLETE
If any errors are reported, refer to the Hardware Errors section in this chapter.

Disk Information Status (L DMAP)

Beginning with Serenade 3.0, the L DMAP command is used to display characteristics of each drive
installed in the system. You must connect to the VCU software before you can enter this command. You
can determine the drive status, the drive manufacturer, the physical and logical size of each disk, and how
the disk is keyed from the information displayed.
At the @ prompt enter:
VCU
A> appears. At the A> prompt enter:
L DMAP
To return to the @ prompt, enter:
E
Enter
PB60019−01
This argument specifies which regions to test:
1 = Critical sectors
2 = File system
4 = Prompts
8 = Message headers
10 = Voice data
= All regions
Enter
Voice drives have two types of regions, Critical sectors and Voice data. When
running DEX to test all regions for all system and voice drives (that is, DEX FF),
invalid regions of the voice drives are ignored, but the corresponding regions on the
system drives are exercised.
.
The DEX report for a voice drive region that does not exist displays zero
errors.
The following example shows all regions on disk 1 tested:
DISK #1:00000
DISK #4:00000
DISK #1:00004
DISK #4:00000
DISK #1:00003
DISK #4:00000
DISK #1:00000
DISK #4:00000
DISK #1:00012
DISK #4:00000
Enter
Enter
.
Maintenance Commands
DISK #2:00000 DISK #3:00000
DISK #5:00000 DISK #6:00000
DISK #2:00000 DISK #3:00000
DISK #5:00000 DISK #6:00000
DISK #2:00000 DISK #3:00000
DISK #5:00000 DISK #6:00000
DISK #2:00000 DISK #3:00000
DISK #5:00000 DISK #6:00000
DISK #2:00000 DISK #3:00000
DISK #5:00000 DISK #6:00000
6-33
Octel 200/300 S.4.1