Avaya Octel 200 Installation And Maintenance Manual page 262

6-20 Installation and Maintenance Volume
.
The SINGLE DIGIT MENU MAX DIGIT: and PREFIX DIGITS: fields are for a Single
Digit Menu that was created through the USER Table. Entries in these fields override any entries
made in INFORMATION Table indexes 4 and 5, associated with the COS for the mailbox.
The FLAGS: field describes the state that the mailbox is currently in. The following definitions are for
the flags that might occur.
Screen Text
LOG-ON
SD-USE
IS-FUL
IN-RNG
HASMSG
MW−CAL
LMP-ON
LP-CAL
FX−DEL
LPRTRY
INTGIP
.
Distribution lists are not mailboxes and cannot be listed with this command.
Use L M x M as an extension of the mailbox configuration status command to list all the messages and
their status for a specific mailbox. To list message information for the mailbox, you must add the letter M
to the command. At the @ prompt, enter
L M x M
For this command, x is the mailbox number.
An example of this extended command follows:
@L M 2000 M
STATUS
10 NEW
10 NEW
FAX STATUS
00
08 FAX
The STATUS, MSG, and CRE columns display information about voice and fax messages. To determine
whether a message listed in these fields is a fax, refer to the FAX STATUS column of the corresponding
row. If a message is a fax, the fax status is described in the column.
For messages in a mailbox that uses the Serenade TUI, when a message is accessed (even if it is not
heard) the STATUS changes from NEW to LSN. An example is when a mailbox holder has two new
messages and presses
For messages in a mailbox that uses the Aria TUI, the status changes from NEW to LSN only after the
message has been listened to for at least three seconds. You can change the three−second parameter by
changing Application Delay 145.
Octel 200/300 S.4.1
Definition
— Mailbox holder currently logged on
— Mailbox in use by SEND TASK
— Mailbox full
— Message waiting in range for this mailbox
— Mailbox with a newly received message
— Message waiting call in progress (or shortly will be)
— Message waiting lamp turned ON
— Calling to turn ON/OFF lamp
— Fax delivery
— Lamp-message-waiting command retry
— Integration lamp command in progress
Enter
MSG CRE STATUS MSG
50B6 003E 20 SAV 501D 003E
51AC 003E 40 LSN 13FA 0000
FAX STATUS
08 FAX
28 FAX PERSNL
followed by
5 5
CRE STATUS MSG CRE
48 LSN 5008 0002
40 LSN 5007 0000
FAX STATUS
08 FAX
00
immediately, both messages are marked as LSN.
STATUS MSG CRE
10 NEW 5187 003E
40 LSN 3002 0000
FAX STATUS
00
18 FAX GROUP
PB60019−01