Table of Contents
Advertisement
Quick Reference Guide
Command
Subject
Type
Test
System Initialization
Commands
(continued)
Floppy Disk Drive
Integration Card
LIC
Network Routes
System Status
Fax Application
Processor
Octel 200/300
S.4.1
Command
Information
Initializes and cancels forwarding for all ports
TE C 2 x y
specified. Sends initialization string from System
or
Parameter 33 —
CU x y z
cancels forward string from System Parameter 46
—
SYSTEM RELOAD CANCEL-FORWARD STRING
x = slot number
y = port number or first port in a range of ports
z = port number of the last port in a range of ports
Isolates faults to floppy, disk drive or disk
TE F 1
controller.
Tells the integration card to run its link selftest.
TE INT x y
Used only for systems with integration cards.
x = slot number
y = unit number
Checks tone generation and detection circuitry.
TE L 1
Ring-through test. Use only when no traffic.
TE L 2
Test if loop current is present on a specific port.
TE L 4 x
x = port number
Tone reflection test on one port.
TE L 5 x
x = port number
Tests network routes to a network location.
TE NET x y
x = network location code (optional)
y = non-zero show digits entered
Checks voltages and temperatures.
TE S
Fax loopback test. Verifies fax modems on Fax
TE X x y z
Application Processor can send and receive fax
data and that the TDM bus connection is correct.
x = slot number
y and z = fax channels
Octel 200/300
Maintenance Commands
PBX INITIALIZE CODE
, then
.
PB60019−01
Advertisement
Chapters
Table of Contents
