Install Core 1 Hardware - Avaya Communication Server 1000M Series Upgrade

Page 58 of 198 Performing the upgrade

Install Core 1 hardware

Table 9
Core module ID switch settings (System Utility card)
Core 0
Core 1
NN43021-459 Standard 05.04
Install the NT4N41 Core/Net module and pedestal next to the existing
column, or on top of the column if you are installing a stacked configuration.
For information about AC/DC power, side panels, and EMI spacers (placing
the fourth module on a column), see the appropriate chapters in
Communication Server 1000M and Meridian 1 Large System Installation
and Commissioning (NN43021-310)
Procedure 8
Checking main Core card installation
The main Core cards are installed in the factory as shown in Figure 16 on
page 59.
1 NT4N65AC CP Core Network Interface (cCNI) cards:
Each system contains one NT4N65 cCNI card per Core/Net module. The
cCNI cards are located in slot c9. If not already installed, install a
P0605337 CP Card Slot Filler Panel to cover slots c10-c12, which do not
contain cCNIs.
Note: In the NT4N41 Core/Net
Network Interface (cCNI) Card in slot c9 can only be configured as group
0. The cCNI and 3PE cards for group 0 communicate through the NT4N29
cable. Only one cCNI card is required for group 0 in a Meridian 1
Option 61C CP PIV.
2 Slots c13 and c14 are left empty. If not already installed, install a
P0605337 CP Card Slot Filler Panel in each slot.
3 The NT4N48 System Utility (Sys Util) card is located in slot c15. Check
the side ID switch settings for the SU card in Core/Net 1 according to
Table 9.
Position 1
On
Off
4 NT4N39 CP PIV is located in the Call Processor slot.
March 2012
module, port 0 on the NT4N65 Core to
Position 2
On
On